Emerald Management Cool Site Award

Machine Downtime, cost justification information, six sigma, lean manufacturing, total quality management, project management, change management, manufacturing training, quality manual, proccess mapping, OEE

Expand | Collapse

HOME

 
 Main Categories
 Sub-Categories A-Z
 What's New
 Resources
 Services

TDC - Maintenance Reduced Production Category

These are per downtime occurrence entries, but most can be exported from your CMMS. Your existing method of reporting need only meet the TDC recommendations below.

Under the main category "Equipment", sub category "Start up" is where you would place the percentage of reduced production from full capacity during a start up. This category is for time and percentage of full capacity equipment is running a reduced rate due to a malfunction.

This malfunction may have not been reported for some time, or scheduled for planned downtime repair, or other reason for running at a reduced production rate for an extended period of time. Malfunctions that only reduce production communally have the lowest priority, and sometimes the cost is never reported. After learning about OEE, you'll know everyone is running at a reduced rate. For now reduce rate will refer to running less than normal benchmarked production rate.

Common causes for reduced production rates...

  • Bottlenecks and other material shortages

  • Equipment failure,  troubleshooting and waiting for repair

  • To maintain quality and low reject rates

  • A non-reported, or unscheduled for repair "annoyance" problem
  • Operating with band-aid
  • In-line production equipment installation
  • An undetected drop in production rate
  • Poor working conditions (human factor)
  • Run till failure policy

Some may think considering the human factor (HF&HE) to be pointing a finger at the machine operator. I remind you of a very common example in defense. Number of product out of the machine is the primary gauge for a supervisor's success in most facilities. (instead of quality product out the door.) This misdirected focus has caused some supervisors to bump machine speeds (Drive settings for example) up within the electrical control panels. Without the proper technical knowledge of a machines' operating parameters, this often results in shortened life, and increased unplanned downtime.

If you are not watching for and recording the above causes for reduced production, you're losing a lot of profits. There is only one sure way to monitor all these factors and that is with sound procedures that are strictly enforced.

Being able to assign a cost to these reductions in production will give you the cost justification to do productibility studies and analyses. As with all TDC methodologies, you will have the necessary information to make more sound management decisions on a proper coarse of action.

See also ...

Cost of Ignoring Human Factors in Manufacturing

 

Please share your examples, factors, and comments.

Your email address (optional)

Enter Real Person verification code "DTC2007"


 

__________________

Go To Top

Business Industrial Network was founded in 1995 Copyright 1995 [Business Industrial Network]. 

All rights reserved. Revised: January 14, 2005.

This web site provided by Business Industrial Network and we make no manner of an endorsement, representation or warranty regarding any contents located on this site. It is recognized that there is a great deal of uncertainty and honest scientific difference of opinion surrounding parameter selection for these future-looking cost analyses. This web site content is provide as a starting point for improving manufacturing cost analysis. Viewers understands that any content or other information offered on or through BIN95.com are provided for informational purposes only. Viewers should evaluate any content or other information offered on or through BIN95.com in light of viewer's own individual circumstances.